DMTA-10055-01EN, Rev. A, February 2015
Chapter 11
228
To activate the DAC/TCG feature
1.
Choose
DAC/TCG
(group 4/5).
2.
Press
Setup
(P7 key) to display the
DAC/TCG
setup page (see Figure 11-2 on
3.
Press one of the parameter keys (P2 –P6) to select a
DAC/TCG Mode
.
You can also apply the
Ref Correct
(reference correction) option to the digital
analysis of the live A-scan and DAC/TCG mode. The reference correction feature,
when activated, allows full gain manipulation of either the live echo peaks or the
DAC curve while providing the % amplitude or dB comparison of the actual
peak-to-curve ratio. In this way, you can use scanning gain while maintaining an
accurate measurement reading of the ratio of the gated peak to the DAC curve for
sizing purposes. The gated echo amplitude is corrected back to the reference gain
level for amplitude evaluation compared to the DAC curve.
4.
If applicable, set
Ref Correct
to
On
.
5.
Select an optional
Curve Type
(Standard, ASME-3, JIS, and CUSTOM modes),
and
No of Curves
. (Select to allow or deactivate a 20–80% DAC view.)
6.
Press
to return to the live A-scan screen and begin DAC/TCG setup.
Figure 11-2 The DAC/TCG setup page
Summary of Contents for EPOCH 650
