Olympus EPOCH 1000 Series, User Manual

Page: 69 / 364

910-269-EN, Rev. B, June 2011
EPOCH 1000 Series Software Features 57
Figure 3-9 Example of the Angle and Gain permanent parameters
3.1.8 About Direct-Access Parameters
Two buttons for direct-access parameters always appear at the top-right corner of the
software main display, below the
Gain button. By default, the Range and the Delay
parameters appear for these two buttons. Pressing [GATE] makes the G1Start
parameter appear over the Delay button. Pressing [2
ND
F], [RANGE] (DELAY) brings
back the Delay parameter.
Press the desired direct-access key to select the Range , Delay , or G1Start parameter.
Once selected, the button turns yellow (see Figure 3-10 on page 57). Turn the
adjustment knob or press the
[UP] and [DOWN] arrow keys to edit the value.
Figure 3-10 Example of the Range and Delay direct-access parameters
3.1.9 About Measurement Reading Boxes
The measurement reading boxes at the top-left corner of the software main display,
below the message bar, present the icons and digital values for up to six selectable
measurements (see Figure 3-11 on page 57). Refer to section 3.3.3 on page 71 for
details on how to select measurements and for a description of available
measurements.
Figure 3-11 Example of measurement reading boxes with their icons
Press
[ANGLE]
to select Press
[GAIN]
to select
Press
[RANGE]
to select
Press
[2 ND F] , [RANGE] (DELAY)
to select
Downloaded from ManualsNet.com search engine