22
2
Eyepieces WHSZ15X-H
} The standard 10X eyepieces are clamped using screws.
Using a small flat-blade screwdriver, loosen the clamping screws a of
10X eyepieces and remove eyepieces.
Insert the WHSZ15 X-H into the eyepiece sleeves and tighten the
clamping screws a .
1
2
a
3
Mounting the eyepiece micrometer (optional)
} If you are using 10 X eyepiece, please purchase the eyepiece
micrometer with diameter 24 mm diameter and 1.5 mm thickness.
Loosen the clamping screw of the eyepiece with the small-size flat-
blade screwdriver, and remove the right eyepiece to which the eyepiece
micrometer will be attached.
Hold the eyepiece frame and loosen the reticle holder a to remove it.
Place the micrometer disk a into the reticle holder b with the
indications facing down.
Be careful not to leave dirt on the micrometer disk, as it
will be noticeable during observation.
Screw the reticle holder b containing the micrometer disk a into
the bottom of an eyepiece. Be sure to screw in all the way by hooking
your nail into the notch c on the holder at the end.
Screw the reticle holder a containing the micrometer b into the
bottom of an eyepiece. Screw in the reticle holder a completely
until it touches the end.
Attach the eyepieces to the observation tube, and tighten the clamping
screws.
1
2
3
CAUTION
3
4
5
a
b
Summary of Contents for CX23
Page 30: ...MEMO...
Page 31: ......
