Olympus CLV-180, Maintenance Manual, Page: 10 / 81

Specification CLV-180
1-6
ISSUE1
High-intensity mode (1) When a high-intensity compatible endoscope is inserted, the
high-intensity mode may be selected by pressing the
high-intensity switch. High-intensity mode may not be
selected with endoscopes that are not high-intensity
compatible.
(2) When a high-intensity compatible endoscope is inserted, the
high-intensity mode switch illuminates. This enables the
selection of the high-intensity mode (LED above the switch
illuminates) or the normal mode (LED above the switch goes
out).
(3) The current settings for the high-intensity mode switch are
retained when the power is turned OFF. When a
high-intensity compatible endoscope is inserted, illumination
will either be the high-intensity mode or normal mode,
depending on the settings retained by the system. Initial
factory setting: normal mode.
(4) When the high-intensity mode is terminated (normal mode),
illumination is equivalent to the CLV-U40 EVIS 100 and OES
mode.
(5) High-intensity mode provides approximately twice the amount
of illumination as the SP normal observation mode.
Manual adjustment (1) Mechanical diaphram (set on the panel)
(2) 17 steps
3
.
B
ri
g
h
tn
e
s
s
a
d
ju
s
tm
e
n
t
Automatic adjustment (1) Mechanical diaphram with constant illumination control
(image illumination)
(2) 17 steps
Front panel display
method in special
observation mode
2
.
Il
lu
m
in
a
ti
o
n
f
u
n
c
ti
o
n
4
.
C
o
o
lin
g
Equipment (1) Forced air cooling with a fan (rear exhaust)
Air supply pump (1) Diaphragm system
Air supply pressure (1) Three air supply pressure levels (high, medium, low and
stop)
(2) Maximum air supply pressure: less than 53.9 kPa
1
.
A
ir
Control (1) Through air supply switch settings
3
.
A
ir
/W
a
te
r
s
u
p
p
ly
fu
n
c
ti
o
n
2
.
W
a
te
r
Water supply (1) Supply is available through the endoscope distal end when
a water supply container is attached.
Observation mode Front panel display method
NBI special
observation mode
・
The NBI LED lights up (white)
PDD normal
observation mode ・
The PDD LED lights up (green)
(OE only)
PDD special
observation mode
・
The PDD LED lights up (white)
(OE only)