DMTA069-01EN, Rev. D, March 2017
Chapter 2
28
Figure 2-7 Probe-holder assembly parts
Removable knob
The removable knob mounted on the swing arm allows for a precise positioning
of the probe holder along the slide assembly or the slide bar (see Figure 2-7 on
page 28).
Swing arm
The swing arm holds the yoke and ensures a constant contact pressure between
the probe-wedge assembly and the surface being inspected. A latch knob allows
for releasing the spring pressure to ease the installation of a wedge-probe
assembly (see Figure 2-7 on page 28).
Yoke
The yoke is the U-shaped part holding the wedge-probe assembly. Assembled to
the swing arm with bearings, the yoke rotates to maintain the wedge parallel to
the surface being inspected. The pivot buttons also allow the wedge to swivel (see
Figure 2-7 on page 28).
To latch the swing arm
Lift the swing arm upward until the latch knob engages itself with a click. See
Figure 2-7 on page 28 for the location of the latch knob.
To unlatch the swing arm
1.
Lift and hold the swing arm slightly to remove the spring force on the latch knob.
Removable knob
Split dovetail
Latch knob
Pivot buttons (2)
Mobile yoke arm
Wing knob
Swing arm
Yoke
Summary of Contents for ChainSCANNER
