DMTA048-01EN, Rev. C, February 2013
Connections 27
Figure 2-5 Connecting the power supply to a pump
To disconnect the power supply from the water pump
1.
Ensure that the pump is turned off.
2.
Hold the metallic portion of the power supply connector (Figure 2-5 on page 27).
3.
Pull out the connector from the
DC
IN
receptacle.
4.
Disconnect the power plug from the AC power outlet (wall).
2.2.2
Connecting the CFU-PWZ Power Supply and the Remote Control
This section documents the CFU-PWZ
specific power connection procedures when
you want to use the remote control.
To connect the power supply and the remote control to the CFU-PWZ
1.
Ensure that the pump is turned off.
2.
Align the pins of the remote control LEMO connector with the holes of the
CFU-
PWZ
power connection’s
DC
IN
receptacle (Figure 2-6 on page 28).
3.
Insert the remote control LEMO connector into the pump’s
DC
IN
receptacle.
AC In connection
DC
IN
receptacle
Power supply
LEMO
connector
Power cable
Power supply unit
Power plug
CFU05 unit shown
Downloaded from
Summary of Contents for CFU03
