![background image](http://html2.mh-extra.com/html/olympus/camedia-d-490-zoom/camedia-d-490-zoom_operating-instructions-manual_4200805035.webp)
69
Enlarging the Subject
(Digital Telephoto Mode)
Using the digital telephoto mode, its subject can be enlarged to 1.6x, 2x and
2.5x its original size. The subject can also be enlarged approximately 4.8x,
6x and 7.5x using the optical zoom (p.44).
If you take the picture with the camera set for Digital Telephoto Mode, the
picture quality will become grainy.
1
Open the lens barrier.
• The camera turns on in
shooting mode.
2
Press the macro/digital
telephoto button twice.
• The monitor turns on and the
digital mark is displayed.
3
Press
왕 왓
on the arrow pad
to select the desired
magnification size.
1.0x (initial value)
왕
button
1.6x
2.0x
2.5x
왓
button
4
Aim the camera at your
subject and full-press the
shutter release button.
• The use of a tripod is
recommend to prevent
blurriness caused by camera
movement.
To cancel the digital telephoto mode
Turn off the monitor, or press the macro/digital telephoto button again.
This turns the digital telephoto mode off and returns the size to 1.0x.
The scale remains normal for the optical zoom.
NOTE
• Cannot be used with SHQ-TIFF selected for quality. Select any record
mode other than SHQ-TIFF and take the pictures (p.80).
4
Taking Better Pictur
es
Taking Close-up Pictures
(Macro Mode)
When using macro, you should maintain a distance of 8 to 31 inches
from the subject. While it is possible to take macro photos from any
distance, shots taken at less than 8 inches or farther than 31 inches
are likely to be out of focus or poorly exposed.
Minimum distance: approximately 8 inches
Telephoto: If you wish to further enlarge the image, push the zoom
lever toward T (telephoto).
Monitor is filled by a 3
″ ×
2
″
subject.
Wide-angle:If you wish to make the image smaller, push the zoom
lever toward W (wide).
Monitor is filled by a 6
″ ×
8
″
subject.
1
Open the lens barrier.
• The camera turns on in
shooting mode.
2
Press the macro/digital
telephoto button.
• The monitor turns on and the
macro mark is displayed.
• The macro mark is also
displayed on the control panel.
3
Aim the camera at your
subject and full-press the
shutter release button.
To cancel the macro mode
Turning the power off or switching to
digital telephoto mode will turn the
macro mode off (p.69).
HELP
• Dark shadows may appear when
using the flash.
NOTE
• In macro mode, the picture area will
not be entirely visible within the frame
of the viewfinder. Using the monitor as
a viewfinder is recommended (p.58).
68
Monitor
Control panel
Macro mark
3
2
2.0
x
Digital mark
4
2
3
앖
앗
Magnification size
Monitor