Olympus CAMEDIA C-8080 Wide Zoom, Quick Start Manual, Page: 144 / 345

91
Remote control shooting
5
Advan
ced shoot
ing
TIPS
The self-timer/remote control lamp does not blink after pressing the
shutter button on the remote control device.
o
The remote control device may be too far from the camera. Move closer to
the camera and press the shutter button on the remote control device again.
o
The battery in the remote control device is running low. Replace with a new
battery.
g
“How to replace the battery (CR2025) of the remote control
device” (P.220)
How to cancel the remote control mode.
o
The remote control mode is not canceled automatically after shooting.
Perform Step 2 and set the mode to OFF.
• If the remote control receiver is exposed to strong light, the effective signal
distance may be reduced or shooting may not take place.
• To shoot sequential shots using the remote control device, press and hold
the shutter button on the remote control device. If the camera does not
receive the remote control signal properly, sequential shooting may stop.
Changing the time until remote control is activated
You can select the time from when the shutter button on the remote control
device is pressed until the picture is taken.
AUTO The picture is taken immediately the shutter button on the remote
control device is pressed.
3 SEC The picture is taken approximately 3 seconds after the shutter
button on the remote control device is pressed.
1
Press
e
while holding down
B
.
• In
Y
mode, the menu is not displayed when
e
is
pressed.
2
Press
ac
to select AUTO or 3 SEC, then
press
e
.
Note
Arrow pad
OK button
B
Self-timer/Remote control
button
3 SEC
AUtO
GO SELECt