BondMaster 600 — Getting Started Guide
5
To Start Up
When power is turned on, the BondMaster 600 starts up
in one of two modes, depending on what is connected to
the instrument.
If no probe is connected, or if a probe that is not a
PowerLink type of probe is connected, the first screen
displayed by the BondMaster 600 software is the
application quick-setup menu. From this menu, choose
a basic application to automatically configure the
appropriate instrument settings.
The BondMaster 600 applications are designed for quick setup of the instrument. However, always
follow published maintenance procedures when inspecting.
To Navigate the Application Menu
Navigating the application menu is designed to be intuitive, and the settings for each application are
designed to permit immediate inspection; little or no additional instrument setup is needed.
1.
Rotate the knob to highlight one of the applications.
2.
Press the Enter key (
) to select the application.
OR
Press the Return key (
) to go back to the BondMaster 600 main screen.
Alternatively, if a PowerLink probe is connected to the instrument before it is turned on, the
BondMaster 600 starts up in the PowerLink recognition screen, and you can proceed as follows:
In the PowerLink recognition screen, load the
program stored in the PowerLink probe by pressing
the A key. This automatically sets up the
instrument.
OR
Bypass the stored program in the probe and gain
access to the instrument’s main inspection screen by
pressing the Return key (
).
NOTE
