DMTA-10022-01EN, Rev. C, January 2015
Software User Interface Elements
41
8.
To complete editing of the parameter value, highlight
DONE
on the virtual
keyboard, and then press
[ENTER]
.
When editing a multiple line parameter value, highlight
DONE
and press
[ENTER]
to
move the cursor to the next line. You can also press
[2nd F]
,
[
]
to accept the text and
move the cursor to the next line.
3.4.2
Editing Text Parameters Using the Traditional Method
When the
TEXT EDIT MODE
is set to
TRADITIONAL
, select each character from a
hidden circular list of standard sorted letters, numbers, and special characters (see
Figure 3-10 on page 41). Only uppercase letters are available.
Figure 3-10 The character cycle of the traditional text edit method
To edit an alphanumeric parameter value using the traditional method
1.
Select an alphanumeric parameter.
NOTE
[
]
Cycling begins at “A” when the
original character is a letter.
Cycling begins at “0” when the
original character is a digit.
[
]
Summary of Contents for 45MG
