DMTA-10022-01EN, Rev. C, January 2015
Chapter 7
134
The thickness value and the alarm indicator only appear in color when the indoor
color scheme is active (see “Color Schemes” on page 47 to change the color scheme).
REDUCTION RT
The
REDUCTION RT
option only appears when the active file is configured with
FILE DATA MODE
set to
REDUCTION RT
. You set the reduction percentage for
the low (
YELLOW ALARM
) and high (
RED ALARM
) limits, following which the
instrument displays (see Figure 7-6 on page 134):
•
The
RED
indicator for reduction rates that are greater than or equal to the
RED ALARM
value.
•
The
YEL
indicator for reduction rates that are between the
YELLOW ALARM
and the
RED ALARM
values.
•
The
GRN
indicator for reduction rates that are below the
YELLOW ALARM
value.
Figure 7-6 YEL (yellow) and RED alarm indicators (shown with the Waveform
option activated)
To set the alarm
1.
In the measurement screen, press
[SETUP]
, and then select
ALARM
.
NOTE
YEL
alarm indicator
RED
alarm indicator
Summary of Contents for 45MG
