Olympus 45MG, User Manual

Page: 127 / 246

DMTA-10022-01EN, Rev. C, January 2015
Software Options 117
To review stored data and change the active ID
1. Open the file you want to review (see “Opening a File” on page 106).
2. In the measurement screen, press [2nd F] , [FILE] (ID#) .
3. While in the ID review screen (see Figure 6-36 on page 116), perform the
following actions:
a) Review the waveform, status flags, and measured values for the active ID.
b) Press [

] to display the data for the next ID in the file.
c) Press [

] to display the data for the previous ID in the file.
d) Press [2nd F] , [

] and [2nd F] , [

] to jump respectively to the last ID and the
first ID in the file.
e) Press [2nd F] , [FILE] (ID#) to edit the ID (see “Editing the ID” on page 117).
4. Press [MEAS] to return to the measurement screen with the new active ID.
6.7.6.2 Editing the ID
The ID can be edited as follows:
• Change the active ID to quickly jump to an existing ID. This is useful when you
are using a large file, and it would take too long to locate the desired ID using the
arrow keys.
• Change the active ID to a new ID that does not yet exist in the file. This mode is
useful when you want to include additional measurement points in the active file.
Additional IDs can be added anywhere in the database (beginning, middle, and
end).
No stored data is shown while the ID is being edited.
To use the ID edit mode
1. Open the file containing the ID you want to edit an ID (see “Opening a File” on
page 106).
2. In the measurement screen, press [2nd F] , [FILE] (ID#) .
3. Select the ID you want to edit (see “Reviewing Stored Data and Changing the
Active ID” on page 117).
NOTE