4
Introduction
The Olympic Dental Table is a fully adjustable dental table designed to provide better patient presentation,
save time and improve operator comfort.
The Dental Table is adjustable in four ways to meet the needs of the operator: Height adjustable from 29" to 41".
Table Top can be tilted down to a maximum of 10 degrees for drainage. Each Table Top panel can be lifted up
to 45 degrees for dorsal positioning. Instrument tray adjustable from left to right of table.
The Olympic Dental Table also has a complete, self-contained drainage system, which collects any fluids from
the Table top as well as fluids passing through the Dental Screen in a removable Drain Pan located under the
Head Support.
Safety
Please read and follow the instructions in this manual, including all safety instructions and precautions,
carefully and completely.
The user should be aware that the Dental Table is a powerful machine with moving parts capable of causing injury
if proper precautions are not taken. The lift is raised and lowered by means of an electrical actuator, and care
must routinely be taken to assure that hands, feet and other body parts are not in the path of the lift mechanism.
Caution: Do not use the Dental Table for patients weighing more than 250 pounds.
Unpacking and Setup
Warning: The Olympic Dental Table is heavy
and requires at least 2 people to unpack and
move in order to avoid injury to staff or damage
to the product.
Caution: Do not lift the table by grasping the
table top as this can result in permanent damage
to the unit.
Note: If you suspect concealed shipping damage,
please save all packaging and contact Olympic
Veterinary immediately at 1-800-789-6867.
1.
Move the pallet to a level location as close
as possible to the intended installation site.
2.
Remove the shrink wrap and the cardboard lid,
then completely peel off the cardboard shroud.
3.
Cut the 2 tie-down straps securing the cardboard
carton to the table top and set the carton aside
until the table has been rolled to its final destination.
4.
The table is bolted to the floor of the pallet with
4 L-shaped brackets
A
secured by 12 hex head
screws. Remove all 12 screws using the included
Hex Head Wrench.
5.
Remove the 2x4 retaining board
B
located in front
of the dental table from the floor of the pallet by
sliding it out of the slotted enclosure.
E
D
A
B
C
Figure 2