Olympia PS 710.3 CCD, Operating Manual, Page: 23 / 94

23
11 Troubleshooting
Problem Diagnosis & Cause Solution
Device does not
work
Is the power plug connected
properly in the power socket? Connect the power plug to the
power socket properly.
Is the On/Off switch set to
OFF ?
Set the On/Off switch to its ON
position.
Is the AUTO function activated? Press the AUTO button.
Has the device been assembled
properly? Ensure that the waste bin has
been inserted properly.
Does the motor fail to start
when paper is inserted?
Slide the paper in the
respective infeed slot so that it
makes contact with the sensor
in the middle.
Device no
longer functions
after a longer
period out of
service or stops
during operation
Was the device shutdown for a
longer time? Is the surface of
the device warm? The
permissible operating cycle has
probably been exceeded.
First of all, disconnect the
power plug from the power
socket and allow the motor to
cool down to room temperature.
For information on the operating
cycle, refer to Chapter
"Technical Data".
Overloading
(material jam)
Have you exceeded the
permissible material capacity
(refer to Chapter "Technical
Data")? Has the material been
fed in askew?
Clear the material jam, refer to
Chapter "Clearing a material
jam".
Note: If you cannot clear the fault yourself, contact your dealer or call the Olym-
pia hotline.
12 Disposal
This symbol (crossed out waste bin) indicates that the product must be
returned to an authorised recycling centre or separate collection point when
it has reached the end of its service life. The symbol only applies to states
within the EEA (*)
(*) EEA = European Economic Area, which is comprised of the member
states of the EU plus Norway, Island and Liechtenstein.