Olympia PS 33T, Manual Instruction

Page: 15 / 66

15
Connecting the power supply
Connect the power plug to a power socket. Pay attention to the information regarding
power supply on the rear side of the device for the necessary precautions.
Important information : The power socket and power connection on the device must be
freely accessible for reasons of safety, namely to enable the power supply to be discon-
nected quickly in an emergency!
Set the sliding switch to
Auto .
Operation
Sliding switch
The sliding switch is used to control the cutting mechanism in the paper shredder. The
switch can be set to three positions:
Position
Rev : Continuous reverse running.
Position Fwd : Continuous forward running.
Position Auto : The device is ready to operate. The cutting mechanism automatically
starts to run forwards as soon as paper is inserted in the paper infeed and detected by
the mechanical sensor. The paper is then drawn in automatically. The cutting mechanism
continues to run approx. 2 to 4 seconds after the last sheet of paper has been inserted.
The device then switches off automatically.
Shredding paper

Set the sliding switch to Auto or Fwd .

Insert paper from the top and straight into the paper infeed
(max. 5 sheets A4, 80 g/m²).
Note: Do not exceed the sheet capacity recommended in the technical data, otherwise
the paper will jam! Do not forget that the thickness of the paper increases when folded,
as a result of which the recommended sheet capacity can be exceeded. Also reduce the
quantity of paper when shredding coarse paper.
Emptying the waste bin
It is recommended not to allow the waste bin to fill up until the cuttings reach the cutting
mechanism. This prevents the shredded paper congesting and jamming in the cutting
mechanism.
Empty the waste bin regularly. Ensure that the sliding switch is set to
Auto and discon-
nect the power plug!
Clearing a Paper Jam
If too much paper is fed into the cutting mechanism, a paper jam occurs.
Proceed as follows:

Move the sliding switch to Rev (Reverse).