Or the shower and crown of the unit 13 are blocked by coffee deposits.
What to do clean all the pieces as indicated under the heading
"CLEANING".
Or the machine is full of calcium deposits.
What to do: remove these deposits following the instructions under the
heading "DECALCIFICATION".
... the machine is on, i.e. switch 7 is on, but the heating light 8 remains off
and, on pressing the coffee switch 10, cold water or coffee is released from
the group 13.
Then the machine has worked without water in the boiler and has been
automatically switched off by the thermal safety valve.
What to do: switch the machine off by pressing 7. Turn on the steam tap 5,
release all the steam from the spout 14 of the steam pipe, then turn off the
steam tap 5. Check the water in the container under the lid 2 and in the
water level gauge 3: if there is little or none at all, add some as instructed
under the heading "CHECKS WHEN THE MACHINE IS IN USE". Let the
machine cool for about 30 minutes and then turn it on again by pressing
switch 7: the thermal valve will automatically set it working. Then follow
the instructions under the heading "STARTING PROCEDURE",
... the machine is on, i.e. switch 7 is on, the heating light 8 stays on (it does
not go on and off at regular intervals), it does not heat properly and the
boiler makes a noise. Water comes out of the spout 14 of the steam pipe
instead of steam.
Then you have not used the machine properly or the boiler contains heavy
calcium deposits.
What to do; - Turn on the steam tap 5 fully as perhaps this has not been
done properly.
- Check the water in the water level gauge 3: if
it is above the point indicated by the upper arrow as in the illustration, put
the jug g under the spout 15, turn on the hot-water tap 6 and release some
water until the water in the water level gauge 3 falls to the point indicated
by the upper arrow as in the illustration.
- The machine should be decalcified as instructed
under the heading "DECALCIFICATION".
Summary of Contents for Caffarex
Page 1: ......
