17
Operation
1. Connect the power cable to an easily accessible, standard electrical so-
cket.
Attention:
Check that the voltage specifications of the machine cor-
respond to that of your power supply network (220 - 240 V /
50 Hz).
2. Switch on the power switch at the rear of the device and then switch on
the On/Off button (ON/OFF) on the operating panel.
3. The drive motor for the transport rollers starts up, the red LED (Power)
lights up and the warm-up phase begins.
4. The correct operating temperature is reached after about 4 - 6 minutes
and the green LED (Ready) lights up.
5. Set the thickness of the laminating pocket using the Up and Down but-
tons, if it needs to be altered.
Note:
Only use laminating pockets of at least 80
μ
m and maximally
250
μ
m.
6. Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Attention:
Only use hot laminating foils.
7. Insert the foil pocket containing the document in the laminator's inserti-
on slot. Insert the ready closed side of the foil in first. The foil pocket,
with the document inside, is automatically drawn in and sealed.
Note:
To prevent the foil pocket from creasing, never feed the
open side of the laminating pocket first in the insertion slot of
the laminator.
Attention:
The foil is very hot and soft when ejected following lamina-
tion. Therefore, handle the laminated product with extreme
care.
Note:
To flatten the laminated product, place a book or similar
heavy, flat object, on it.
Note:
If the device is used continuously, the blue LED may light up
occasionally to indicate reheating. This does not affect the
quality of the lamination process.