Olympia A 245 Combo, Manual

Page: 25 / 86

25
g
Cleaning the Transport Rollers
Adhesive residues and other deposits on the rollers can impair the lamination result. Remove
these at regular intervals and whenever the lamination result is not as good as expected.
1
Set the On/Off switch
7
to
HOT (II)
.
Ä
The transport rollers start to rotate.
Ä
The POWER LED
5
lights up RED .
2
Wait 2 - 3 minutes until the laminator has warmed up.
Ä
The READY LED
6
turns GREEN , when the device has reached the required operat-
ing temperature. The POWER LED
5
lights up
RED
.
3
When the device has reached operating temperature, insert a sheet of A4 paper in the
infeed
9
of the device until the transport rollers clamp it.
Ä
The paper is transported through the device and is discharged at the output
12
. All the
residues are deposited on the paper.
Caution ! Risk of burns through hot residual laminated material. After cleaning, very hot
residual laminated material is stuck to the ejected paper. Only remove the paper
discharged by holding it at the cooled end.
4
Repeat this process several times to clean the transport rollers.
Ä
The transport rollers of the laminator have been cleaned.
Technical Data
Subject to change without prior notice.
Model number Olympia A 245 Combo, Art. No. 3170
Power supply
230 V ‒ 240 V, 50 Hz
Current strength
2.0 A
Power consumption, max.
450 W
Pouch thickness
80 ‒ 125 micron
Maximum document thickness
Up to A4, 210
×
297 mm (8 1/4″
×
11 3/4″)
Heat-up time Approx. 2 ‒ 3 minutes
Laminating speed
Approx. 300 mm/min
Maximum document thickness 0.6 mm
Max. cutting capacity 3 sheets
Max. cutting length 310 mm
Weight 1 kg
Dimensions (W × D × H)
363
×
140
×
79 mm
Colour black