WWW.OLYMPIA-TOOLS.CO.UK |
13
AFTER SALES SUPPORT
| +44 (0) 1904 727512
12
| 20V LI-ION CORDLESS DRILL DRIVER
Checking the battery pack capacity (See fig. G)
Check the battery capacity via the coloured LEDs.
Press the button and check the LEDs:
Light
Status
Red on
Battery too low
Red + yellow
Battery half charged
Red + green
Battery fully charged
Fig. G
Disposal of an exhausted battery pack
Olympia Tools provides a facility for the collection and
recycling of rechargeable LI-ION batteries once they have
reached the end of their working life. To dispose of your
battery please return to any Olympia Tools stockist who will
collect them on our behalf. Alternatively consult your local
waste authority for information regarding available recycling
and/or disposal options. It will then be recycled or dismantled
in order to reduce the impact on the environment. Battery
packs can be hazardous for the environment and for human
health since they contain hazardous substances.
Discharge your battery pack by operating your drill, then
remove the battery pack from the drill housing and cover the
battery pack connections with heavy-duty adhesive tape to
prevent short circuit and energy discharge. Do not attempt
to open or remove any of the components.
Overload protection
When overloaded, the motor comes to a stop. Relieve the load
on the tool immediately and release the On/off switch. Restart
the tool as normal.
Temperature dependent overload protection
When used as intended the power tool cannot be subject to
overload. When the load is too high or the allowable battery
temperature is too hot, the electronic control switches
off the power tool until the temperature is in the optimum
temperature range again.
Protection against deep discharging
The LI-ION battery is protected against deep discharging
by the “Discharging Protection System”. When the battery
is empty, the tool is switched off by means of a protective
circuit. The drill will no longer rotate. Remove the battery
and recharge.
TROUBLE SHOOTING
Why does the drill not turn on when you
press the switch?
The forward/reverse rotation control, which is on top of the
trigger, is positioned in the lock function. Unlock the forward/
reverse rotation control by putting it into the required rotation
position. Push the trigger and the drill will start to rotate.
The drill stops before the screw is completely
tightened. Why?
Verify the torque position of the torque adjusting ring, you
can find the torque-adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving force)
and position 19 is the highest torque (screw driving force).
Regulate the torque adjusting ring to a higher position to reach
the best result.
Reasons for different battery pack
working times
Prolonged storage of a battery pack without use will reduce
the battery pack working time. This can be corrected after
several charge and discharge operations by charging and
working with your drill. Heavy working conditions such as
large screws into hard wood will use up the battery pack
energy faster than lighter working conditions. Do not
re-charge your battery pack below 0
o
C and above 45
o
C
as this will affect performance.
MAINTENANCE
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working
controls free of dust.
Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
TROUBLE SHOOTING
|
MAINTENANCE
OPERATION INSTRUCTIONS
Press
LI-ION