Page 2 from
3
the battery should be connected (the
battery should be charged)
.
If the battery
is not charged
,
the test is postponed
until
the battery is completely charged. If during
the Automatic Autonomous Test the
luminaire’s duration is lower than the
n o m i n a l , t h e n t h e b a t t e r y m u s t b e
replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least the one that is
stated in the technical characteristics.
During emergency mode, a LED strip test
is also performed.
Resetting Errors
Push the TEST/RESET button for 5
seconds, to extinguish all the indicated
LED errors (page 3). Then the luminaire
enters regular
operation mode.
Indication LED status
(with connected mains power supply).
Charge
On:
Good charge current.
Οff:
No battery
(
No charging current or
disconnected battery
).
Lamp Fault
Οn:
Faulty LED strip.
Off:
Good LED strip.
Battery Fault
Ο
ff
:
Battery OK.
Blink
(
With
Charge LED
ON): Autonomy
or low battery problem
(the battery must be replaced).
Blink
(
With
Charge LED
Off):
No charging current or disconnected
battery
.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation, maintainance
or testing must be done by authorized
personel only
.
2.
The device must be connected to the
mains power supply through a fuse
dependent by the total amount of the line’s
power load
.
3.
In case of battery or lamp replacement,
these must be replaced by parts of the
same type, by the manufacturer or by a
competent person.
4. In case of inactive use for a period
greater than 2 months, disconnect the
battery by pulling out the battery’s
connector.
5.
I s not allowed to discard batteries in
t i
to common trash bins, they must be
discarded only
in battery recycling
points. Do not incinerate.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X:
Self contained
1:
Maintained (*)
A:
Including test device
480:
8 hour duration
(*)
Maintained operation: The luminaire
lights its illumination source, when it is
powered by the mains power supply or not
.
Non Maintained operation: The luminaire
lights its illumination source,
only in power
supply’s failure.
NOTE!! After finishing the installation
you must power the luminaire at least
for 24 hours for battery charging to
perform the nominal autonomy.
Battery replacement
1. Unfasten the 4 retaining screws
(
step 10
of the installation instructions
)
and remove
the diffusor.
2. Unfasten the 2 retaining screws step 9 of
the installation instructions and remove the
reflector.
3. Remove the old battery and place a new
on of the same type and characteristics.
4. Replace the removed parts (previous
steps 1,2).
923940002_09_003