LED MODULE CHARACTERISTICS
Olympia Electronics S.A
.
65 °C max. across the board
2,8-2
,
9V DC
3-3,1V DC
1W
2
W
0405183
GR-4
90
/WP/ADR GR-4
9
1/WP/ADR GR-4
9
2/WP/ADR GR-4
9
3/WP/ADR
E:
With non-replaceable lamp(s)
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:X:
Self contained
0:
Non maintained
(*)
A:
Including test device
B:
Including remote test mode
C:
Including inhibiting mode
with IEC 61347-2-7 denoted EL-T
90:
1.5 hour duration
180:
3 hours duration
(*)
Non Maintained operation: The luminaire turns on illumination source,
only in case of power supply
failure.
F:
Automatic test gear complying
fixed connection between main pcb and led module
TEST
A-1900
For
Autonomy Test
, you must place the card in front of TEST
and
hold it for 5 to 10 seconds.
Test
and
Faults R
eset operations with the A-1900 card (not
included and available
after
request).
For
lights
test, you must place the card in front of the TEST
indicator and remove it immediately.
To reset errors
you must place the card in front of TEST by
holding it for
10
to 1
5
seconds and removing it.
Page
6 from
9
the position of the old one.
1. Detach the front cover by applying pressure using a flat blade screw driver. Next, unfasten the four
Battery replacement
3
. Disconnect the connector and remove the old battery.
4
. Connect the new battery with the same type (step
2
of the installation
instructions
) and place it in
It can be done only by a competent person and after the mains interruption
.
5
.
Replace the removed parts
and power the device.
retaining screws without removing them and remove the diffusor.
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
CAUTION
:
Do not view directly with bare eyes
X
0
8
1
0
A
E
B C
F
The light source of this luminaire is not replaceable when the light source reaches its end of life
the whole luminaire shall be replaced.
ATTENTION!!!
92349300
2_0
9
_001