ΑΤΤΕΝΤΙΟΝ
!!!
The autonomous duration of battery during
emergency mode is at least the one that is
stated
in
the
list
of
the
technical
characteristics. During emergency mode, a
light source test is also performed.
2.
The device must be connected to the
m a i n s p o w e r s u p p l y t h r o u g h a f u s e
dependent by the total amount of the line’s
power load
.
3. The replacement of the battery and the light
source must be done using parts of the same
type, by the manufacturer or by a competent
person.
4
.
In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery’s connector.
Resetting Errors
5
.
I s not allowed to discard batteries into
t i
common trash bins, they must be
discarded only
in battery recycling
points. Do not incinerate.
Push the Test button for >10 seconds, to
delete all the indicated LED errors. Then the
device enters regular
operation mode.
Test Switch
1. Operations for installation, maintainance or
testing must be done by authorized personnel
only
.
Pressing the test switch less than 5 seconds
will initiate a light source test (last for 3 secs).
If the test switch is pressed for more than 10
seconds, the device will be reset (delete all
errors).
Back Up Operation
X:
Self contained
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
A:
Including test device
F:
Automatic test gear complying with IEC
61347-2-7 denoted EL-T
9
0:
1
.5
hour duration
18
0:
3
hour duration
(*)
Non Maintained operation: The luminaire
turns on illumination source,
only in case of
power supply failure.
0:
Non maintained
(*)
Page
2 from
6
Status of LEDs
LEDs
Description of indication
CHARGE : Battery charging, : battery charged, : disconnected or unfunctional battery
LAMP FAULT : Operation check, : lamp fault, : normal operation
BATT. FAULT : Autonomy test, : battery fault, : normal operation
Note : Blinking, : constantly on, : off
X
0
9 0
A
F
923293003_09_006
