Siren with beacon with activation button and back up lighting
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM CONSUMPTION
BATTERΥ (Ni-Cd)
INDICATORS
MAXIMUM DURATION OF LUMINAIRE
CHARGE TIME
CONTROLS
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
SOUND LEVEL at 1meter
BATTERY PROTECTION
220-240V AC/50-60Hz
TEST button and manual call point
Charge indication LED
90 minutes
24 hours
IP 40
3,6V/1Ah
Approx. 100 dB
Deep discharge and overcharge protection
3 VA
0 to 40 C
o
Up to 95%
Bayblend FR3010
2 years (1 year for the battery)
520gr.
201 x 142 x 53 mm
GENERAL
Τhe ΒS-3001 is a device that has a siren, beacon, manual call
point and back up lighting with LEDs all in one unit.
It can be activated manually by pressing the manual call point. In
every power supply failure, the unit automatically turns the LED in
back up operation.
In this state, all the functions of the unit operate normally. If an
alarm has not been issued then the back up lighting will operate for
only 90 minutes in order to conserve battery power for an eventual
fire alarm.
If an alarm is given simultaneously with the power supply failure
then the total autonomous duration of the system will be
approximately the same as the duration of the back up illumination.
If the alarm is given after a mains power supply failure then that
total duration of the system will be at least 90 minutes. When the
mains power supply is restored then the unit continues its normal
operation.
The device has a TEST button which activates the back up lighting
for as long as it is pressed.
INDICATION LED
The device has a green LED which is used to show that the
batteries are charging when the
mains power supply is active. An LED that is not lit usually denotes
that the battery is not connected. If the battery is connected then it
usually denotes a faulty battery which must be replaced. Please note
that the microprocessor of the unit manages the battery in the best
possible
way.
RESETTING THE MANUAL CALL POINT BUTTON
To reset the manual call point button, after is has been pressed, to
its original position, use the supplied plastic key. Insert the key into
the slot, rotate 90 degrees and pull on the key until the button locks
into position.
The unit has an input for connecting an external call point button.
The external button must be of the latching type and must have the
same operation as the built in button. The resetting of the call point
button cancels the alarm. The activation of the unit using the call
point button must be done periodically (i.e. Every month) in order to
verify the good operation of the unit.
INSTALLATION
To install the device follow the installation instructions as described
on page 2.
WARNING !!!
1. Every maintenance, inspection and installation operation must be
done only by qualified service personnel.
2. The unit must be connected to the mains power supply via it’s
own dedicated fuse with a rating depending on the total power of the
line.
3.
4.
battery enable’’
It is sugested to check every 6 months the minimum autononous
It is advised that an optical inspection is conducted every month
to verify the operation of the charge LED and the charging of the
batteries. The TEST button should also be pressed to verify the
good operation of the back up. If the back up circuit is not operating
then contact the installer.
In case of inactive use for a period greater than 2 months,
disconnect the battery by removing the battery jumper labeled
‘’
.
5.
921300100_09_006
Page 1 from 3
EN 50130-4, EN 61000-6-3, EN60950-1
BS-3001
ΤΕCHNICAL CHARACTERISTICS
Thank you for your trust in our products
Olympia Electronics - European manufacturer
