70.
Place and align rear and side facia for best possible fit with rear capping side facia. Attach facia
to rafter ends with 6 - 1 1/2” finishing nails per piece. Complete both rear facia pieces.
Rafter/Facia Nailing Plate
Side Angle
Cut Facia
69.
Do a dry run first before securing. Position Front Facia up underneath roof panel and against
rafter ends. Have your helper hold in position. Place angle cut Side Facia underneath roof panel
against Rafter/Facia Nailing Plate. Align so Front Facia caps Side Facia and then attach the front with
6 - 1 1/2” finishing nails. Attach side with 5 - 1 1/2” nails securing them into the nailing plate (closer to
the top of the side facia board). Attach next piece of Front Facia.
Note:
With Front Facia correctly
aligned at corners, a small gap may occur at center seam. This will be covered by Facia Detail Plate
in
Step 72.
Small gap
may occur.
68.
Locate and identify all Facia pieces:
Front & Rear Facia (4)
(1/2” x 4” x 50 1/2”).
Side Angle Cut Facia (2)
(1/2” x 4” x 54 1/8”). In front corner
,
align side and front Facia together
.
Front facia will cap side facia
.
Front
Facia
Front caps
side facia.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 32
