Olsberg Virgo, Installation Instructions Manual

Page: 10 / 20

PAGE 10
2.0 INSTALLATION
2.4 - Flue Installation
The flue outlet diameter on the Olsberg Virgo is 125mm. Appliances are sold equipped with a top or rear
outlet. We would recommend the top outlet connection mode because of combustion technological reasons.
In case you would prefer to connect the stove at the back please refer to the technical data sheet, which
contains the connection height), remove the flue outlet from the top and the closing lid from the back. Put
the flue at the back, and close the top closing lid. Carefully insulate the outlets.
• Readjusting the flue outlet from the back to the top, you need to;
- Remove the flue outlet from the back and closing lid from the top. Put the flue outlet on the top and the
closing lid on the rear outlet.
- Cover the rear outlet with a heat protecting plate also.
• Incase of Top Flue, you need to ensure;
- The height of the connection can be chosen without any restriction but it cannot
exceed 1 meter above the upper edge of the stove. The horizontal part of the connecting pipe must be at
least 40cm from the ceiling. Be certain that there is a hermetically closable cleaning slot at the elbow of
the vertical and horizontal connecting valves
- Incase of stoves with a capacity of 6kW the minimum length of the vertical connecting
pipe is 50cm.
We recommend the use of an insert with a double wall for connecting to the chimney. The insert has to be
installed into the chimney. Then you can connect to the connecting pipe of the stove to it. All combustible
materials have to be removed within a 20cm radius of the insert and have to be replaced by heat resistant/
non combustible material. Install the insert carefully and insulate
If there is wallpaper it is recommended to remove from behind the stove. If the appliance is a corner model,
remove from the sides as well.
• Installation of the connecting pipe;
- Connect the pipe to the flue outlet of the appliance. Push the stove to the chosen location with consideration
of the specified safety distances and install it in such a way that the connecting pipe fits into the prepared
chimney insert. The safety distance from combustible or heat sensitive materials is contained in the
technical data sheet.
NOTICE
All connections must be exact and insulated. The connecting pipe must not reach the free surface of the
chimney. Connections are recommended to be sealed with heat resistant glue. Please ensure before using
your new Olsberg stove for the first time, please refer to user’s manual