Establish the fixing point of the brackets considering
the their penetration into the cracks placed in the back
of the panel
Drill the wall. Apply the fixing brackets with the supplied
screws.
Once the fireplace panel is installed as from the
above instructions, proceed with testing and power
on via the remote control in equipment. Make sure
they have been entered the batteries. The display
should not appear remote control no signal
battery charge check
8
3.9
VERIFY that the air flow in the lower part of the panel is guaranteed. Install the panel at least
25 cm from the floor. The wall must not have elements that could obstruct the correct flow of
air in the lower and upper part of the appliance.
3.10 The panel must be installed so that switches or other controls are accessible. Check that the
electrical system is up to standard. Consult an installer.
3.11 The panel is operated and functions exclusively with the supplied remote control. There are
no manual or manually accessible components in the control panel.
3.12
Do not install the panel in front of electrical sockets.
3.13 After assembling, make sure that the electrical outlet is easy to access and is equipped with a
single-pole interruption device with a separation distance between the contacts of at least
3mm.
3.14 The power cable supplied with the panel is fitted with a die-cast SCHUKO plug. Do not use for
any reason other connections than the plug-cable supplied. Do not use the panel if the cable
is damaged.
