100Base-TX to 100Base-FX Converter
Desktop Installation
Follow the instructions listed below to install the
Converter onto a desktop location.
1. Locate the Converter in a clean, flat and safe
position that has easy access to AC power.
2. Affix the four (4) self-adhesive rubber pads to the
underside of the Converter.
3. Apply AC power to the Converter. (The green
PWR LED on the front panel should light).
4. Connect cables from the network partner devices
to the ports on the front panel. (The green LNK
LED on the front panel associated with the port
should light).
This Converter can also be mounted on a vertical
surface. Simply use the underside of the unit as a
template to measure and mark out the position of the
holes on to the surface where the unit is to be installed.
Then use the two screws provided to mount the
Converter firmly in place.
Warning
Please exercise caution when using
power tools. Also, install this unit away from damp or
wet locations, or in close proximity to very hot
surfaces. These types of environments can have a
detrimental effect on the converter and cables. An ideal
location is a lightly cooled place such as a typical
equipment room.
- 15 -
