Olivetti d-Copia 12, Copier Operation Manual

Page: 19 / 166

When the following indicators light up or blink on the
operation panel or the following symbols appear in the
display, solve the problem immediately referring to both
the table below and the relevant page.
STATUS INDICATORS
Be sure to use only original spare parts and
supplies.
q
s
t
DISPLAYING TOTAL NUMBER OF
COPIES
Use the following procedure to display the total number of
copies:
1. Press the clear (
>
) key to reset the display to zero.
2. Press and hold down the clear (
>
) key for approxima-
tely 5 seconds. The total number of copies will appear
in two steps, each with three digits.
Example:
Total number of copies is 1,234
Cause and remedy
Developer is required. Contact your service centre as soon as
possible.
Replacement of toner cartridge will be needed soon. Obtain a
new cartridge. p. GB-12
Toner cartridge must be replaced. Replace it with a new one. p. GB-12
A misfeed has occurred. Remove the misfed paper referring to the
description of „Misfeed removal.“ p. GB-14. Lever of fusing area
is not raised. p. GB-15. The lower side cover may be open.
If so, close it.
Service by an authorized service technician is required.
p. GB-16
Side cover is open. Close the side cover securely by pressing
the round projections near the side cover open button. p. GB-13
Paper tray is empty. Load copy paper. p. GB-6
A misfeed has occurred in the paper tray. Remove the misfed paper.
p. GB-15
Paper tray is not securely installed. Push the tray in securely.
p. GB-6
The copier will not function. Turn the power switch off and then
switch it on,and if there is again an error, remove the power cord
from the outlet, and contact your authorized service center.
Steadily lit
Indication
Developer
replacement required
indicator
Toner cartridge
replacement
required indicator
Misfeed indicator
Maintenance indicator
“CH” is steadily lit in the
display
“P” is blinking in the
display
A letter and a number
appear alternately.
Q
n
Steadily lit
Blinking
Steadily lit
Blinking
GB-17
GB