Oliver Packaging & Equipment Company
3236 Wilson Drive NW, Walker, MI 49534
(800) 253-3893
747-N BREAD SLICER
0747S20007
6-3
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Installing the Blade Frames
Installation of the blade frames is done by reversing the removal procedures.
1. Tip the lower two front blade frame brackets forward so they hang down to get
them out of the way of getting the back blade frame in position.
2. Tip the two rear lower blade frame attachment brackets up and forward to
receive the tubes on the bottoms of the blade frames. They can lean against the
main rocker shaft. The position of the rocker frame can be tilted so the rear
brackets are higher than the front to make accessing the attachment brackets
easier by moving the belt (as needed, see diagram on the previous page).
3. Identify the rear blade frame (the rear blade frame will have the blade position
toward the outfeed (slicer front) with the sharp edge pointing toward the infeed
(slicer back). If in doubt, refer to the blade frame drawings (page 14-3)
4. Hold the round tubes on the sides of the rear blade frame with the open ends of
the tubes down, avoiding the sharp blade edges. Place the open ends over the
tabs on the rear blade frame bracket and tip the blade frame up into the machine
with the tube ends resting on the brackets.
5. Position the upper rear blade frame bracket into place behind the two “ears” on
the top of the blade frame. The upper rear bracket has the threaded holes.
6. Install the two upper bolts first then the two lower bolts. Securely tighten all four
bolts.
7. Tip the lower front two blade frame attachment brackets up and back so they
lean against the main rocker shaft.
8. Hold the front blade frame by the round sides and place the bottom of the tubes
over the tabs on the brackets inside the machine.
9. Position the front upper blade frame bracket into place in front the two “ears” on
the top of the front blade frame and install the upper bolts. The upper front
bracket holes are not threaded.
10. Pull the bottom of the blade frame forward to bring the lower front bolts in
alignment with the bolt holes in the lower front brackets. Install the two lower
bolts. Securely tighten all four bolts.
CAUTION
ENSURE THE BLADE FRAMES ARE INSTALLED WITH THE SHARP SIDE OF THE
BLADES FACING TOWARDS THE BACK OF THE MACHINE. NEVER INSTALL
BLADE FRAMES WITH THE SHARP SIDE FACING FORWARD. VERIFY ALL
BLADE FRAME BOLTS ARE TIGHT PRIOR TO STARTING THE MACHINE.
