Oliver 797-32N, Instruction Manual, Page: 16 / 54

797-N BREAD SLICER
0797S20025 5-1
TROUBLESHOOTING
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK, INCLUDING
TROUBLESHOOTING.
The Slicer Will Not Start (Motor Is Not Humming)
•
The machine is not plugged in.
•
There is no power at the outlet. (Check by plugging in a small working appliance,
like a lamp. Check to see if a circuit breaker has tripped. If the circuit breaker has
not tripped and the circuit is still not working have a qualified electrician check the
circuit.)
•
The motor switch overload has tripped. (To reset push firmly in the direction shown
on the switch nameplate.)
•
There are breadcrumbs in the motor starting switch. (Have a qualified electrician
disassemble the switch and clean it.)
•
The problem is somewhere in the electrical system of the machine. (Have a qualified
electrician find and repair the problem.)
The Slicer Will Not Start (Motor Is Humming)
CAUTION
DO NOT ALLOW THE MOTOR TO HUM WITHOUT STARTING.
OVERHEATING CAN PERMANENTLY DAMAGE THE MOTOR.
•
The motor has failed. (Have it checked by a qualified electrician.)
NOTE
A SPECIAL NON-VENTILATED MOTOR MUST BE USED WITH THIS SLICER.
•
The drive system is binding. (Have a qualified service agent check for defective
bearings or other restrictions to free movement.)