Oliver 723-N, User'S Operating And Instruction Manual, Page: 5 / 14

0723S20004
ADJUSTMENTS
WARNING
NEVER ATTEMPT TO ADJUST OR SERVICE THIS MACHINE UNTIL
YOU ARE SURE THE BLADE HAS STOPPED.
OUTSIDE SIDE GUIDE
This guide is used to determine the amount of "Hinge" left on the product and can be
adjusted from leaving approximately a 1/2" hinge to a complete sever.
The guide is adjusted by loosening the two knobs which are below and to the outside of
the table and by sliding the guide in or out to generate the desired amount of hinge. Re-
tighten the knobs when the guide is in the desired location.
CAUTION
MAKE SURE THAT THE BLADE IS NOT HITTING ANY OF THE OTHER
COMPONENTS BEFORE RE-STARTING THE MACHINE.
TABLE HEIGHT ADJUSTMENT
The table can be adjusted so that the height of the blade above the table is between 5/8"
and 1-1/2".
To change the height of the blade, loosen the handle located on the left side of the unit.
Once loosened, simply push or pull the handle until you’ve reached the desired height
associated on the slice height gauge. The slice height gauge is located on the front of
the unit. Once the desired slice thickness is achieved re-tighten the handle on the left
side of the base to secure the table in the new position.
CAUTION
MAKE SURE THAT THE BLADE IS NOT HITTING ANY OF THE OTHER
COMPONENTS BEFORE RE-STARTING THE MACHINE.
INSIDE SIDE GUIDE
Generally it is best to leave the inside guide adjusted to the maximum opening, this will
allow the product to pass through uninhibited for maximum slicing speed. However,
some products will require its use to reduce jamming.
(continued on next page)