MODEL 702, 702SE and 702SS BUN SLICERS
REV. 8-28-96
0702S20028
CHANGING THE BLADE
WARNING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL
IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND
YOU ARE SURE THE BLADE HAS STOPPED. ALSO REMEMBER
TO USE CARE WHENEVER YOU ARE WORKING NEAR THE BLADE.
CHANGING THE BLADE
•
Remove the overhead guard assembly by removing the three hex head screws
which hold it in place. Lift the assembly clear of the machine and set it one side.
•
Remove the outside side guide and chute guard assembly by completely removing
both knobs which secure it in place.
•
Using an "Allen" wrench remove the three screws securing the blade to the hub and
lift the blade from the machine.
•
The blade can then be replaced by reversing the above procedure.
•
When reinstalling the blade, make sure that the points on the teeth are pointed in a
counter clockwise direction.
NOTE
LOOKING AT THE SHAFT END OF THE MOTOR THE BLADE SHOULD
ALWAYS ROTATE CLOCKWISE.
WARNING
DO NOT START THE SLICER UNTIL ALL GUARDS ARE IN PLACE
AND SECURELY FASTENED AND YOU HAVE MADE SURE THAT
THE BLADE IS NOT HITTING ANY OF THE METAL PARTS.
Summary of Contents for 702
Page 14: ...MODEL 702 702SE and 702SS BUN SLICERS REV 7 7 10 0702S20021 ASSEMBLY DRAWING MODEL 702...
Page 15: ...MODEL 702 702SE and 702SS BUN SLICERS REV 7 7 10 0702S20029 ASSEMBLY DRAWING MODEL 702SE...
Page 16: ...MODEL 702 702SE and 702SS BUN SLICERS REV 7 7 10 0702S20030 ASSEMBLY DRAWING MODEL 702SS...
