Oliver 625-DR, User'S Operating And Instruction Manual

Page: 12 / 23

625 DOUGH DIVIDER-ROUNDERS
0625S20004-
4
TIGHTENING (Cont’d.)
Loosen the set screws in the two center set collars, (the ones welded to the motor
mounting plate).
Loosen the nut closest to the pivot point on the eyebolt, which passes through the center
of the motor mounting plate. By turning the remaining nut, (which is on the other side of
the mounting plate), clockwise you can increase the tension on the belt. Once desired
tension is achieved secure the motor plate by retightening the nut closest to the pivot of
the eyebolt and the screws in the set collars.
REPLACEMENT
To remove a belt follow the steps above except turn the remaining nut on the eyebolt
counter-clockwise until all tension has been removed from the belt. Swing the eyebolt to
one side and move the motor as close as possible to the driven pulley, thus allowing
removal of the belt.
To replace the belt simply reverse the above procedure and tighten the belt to required
tension as instructed above.
Rev. 3-29-02