7. Mount the support (A, Figure 7) between the
guide rail and the rear rail. Attach the front
side with two M10x16 flat head socket bolts,
two M10 lock washers and two M10 hex
nuts (B, Figure 7).
8. Attach the rear side with two M10x20 hex
head bolts, two M10 lock washers and two
M10 hex nuts.
Fence Assembly and Adjustment
1. Tilt rear end of the fence (C, Figure 8) down
to engage clip (D, Figure 8) on to the rear
rail and lower the fence on to guide rail, as
shown in Figure 8.
2. Move the fence so that the line on the cursor
(E, Figure 9) reads 2” and lock the fence in
place by pushing down on the handle (F,
Figure 8).
3. Place a ruler (G, Figure 9) on the table and
measure from the right side of the saw blade
tooth to the fence. It should read 2”. If not
move the fence so that it is measures 2”
from the blade. Lock the fence in place and
adjust the cursor by loosening the cursor
screws (H, Figure 9) and adjust to read 2”.
Note:
If you do not have enough
adjustment in the cursor loosen cap nuts
that attach the brackets to the guide tube
and slide the tube left or right to get the
proper adjustment. Tighten the cap nuts.
9