Oliver 10060, Owner'S Manual

Page: 28 / 46

28 |
Page Oliver Machinery 10060/10061 Drill Press
Changing Drill Bits
To install a drill bit:
1. Disconnect the drill press from the power
source!!
2. Open the chuck wide enough so it accepts
the shank of the drill bit.
3. Insert the shank portion of the drill bit as far
into the chuck as possible. Make sure the
shank is centered between all three jaws and
is NOT trapped in between the jaws as
shown in this picture.
4. Also, make sure the chuck jaws are not
grabbing the flute of the drill bit, as this may
damage the drill bit, and alter the alignment.
5. Some drill bits have flat-surface shank. Be
sure to align the jaws with the flat surfaces
to maximize the grip.
6. Tighten the chuck by hand, then use the
chuck key to tighten further. It is
recommended to use all three holes on the
chuck and tighten with the chuck key.
7. When finished, put away the chuck key and
keep it in a safe spot.
To remove a drill bit:
1. Disconnect the drill press from the power
source!!
2.
CAUTION
: The drill bit is sharp and can be
hot after drilling. Keep your hands protected
when retrieving the drill bit.
3. Use the chuck key to open the chuck and
remove the drill bit.
4. When finished, put away the chuck key and
keep it in a safe spot.
Changing Speed
1. Disconnect the drill press from the power
source!!
2. Raise the belt cover and loosen the belt
tension lock.
3. Refer to the speed chart for the desired
speed and belt arrangement.
4. Relocate the belts to the desired speed
arrangement.
5. Push the motor away from the head to
tension the belts.
6. Tighten the belt tension lock to hold the belt
tension.
7. Proper tension is less than 1/2” deflection
when squeezing the belt together.
8. Close the belt cover and reconnect the drill
press to power after adjustments.