Table Swing Position
1.
Loosen the
CLAMP LEVER (11)
.
2.
Swing
TABLE (17)
to the desired position.
3.
Tighten the
CLAMP LEVER (11)
.
4.
Align center hole in table to drill bit position to avoid drilling into the table.
5.
For large pieces the
BASE (1B)
can be used as the table.
Changing Speeds
1.
Always disconnect the drill press from the power source before changing speeds.
2.
Raise the
PULLEY COVER (61)
.
3.
Refer to the speed chart for the desired speed and belt arrangement.
4.
Loosen the
LOCK SCREW (27)
and release the belt tension.
5.
Relocate the belts to the desired speed arrangement.
6.
Push the
MOTOR (57)
away from the head to tension the belts.
7.
Tighten the lock screw to hold the belt tension.
8.
Proper tension is less than ½” deflection when squeezing the belt together.
Table Rotation Position
1.
Loosen the
CLAMP LEVER (14)
.
2.
Rotate
TABLE (17)
to the desired position.
3.
Tighten the clamp lever.
Table Tilt Adjustment
1.
Loosen
BOLT (16)
.
2.
Remove
CENTERING SET PIN (13)
.
3.
Tilt the table to the desired position.
4.
Tight the bolt, do not replace the centering set pin.
5.
When moving back to the normal drilling position, replace the centering set pin and tighten.
