Olimpia splendid LIMPIA 4, Instructions For Use And Maintenance Manual, Page: 15 / 40

EN - 6
ENGLISH
PROBLEM SOLUTION
Water vapor and humidity are not
produced.
• Power plug: Unplug and then try again.
• Power Failure: When the power is returned, try again.
• Tank Installation: Make sure the tank is correctly attached.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Air blows but water vapor is not
produced.
• Excessive Water: Remove a certain amount of water from the tank.
• Detergent residue and/or oil ingredients from cosmetics, etc may be in tank; wash out tank
and try again.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• If you use hard water, replace with softer water.
Humidity level is low. • The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• The water in the unit is too cold: Replace with cool, but not cold water.
The humidity has a bad smell. • Poor maintenance or dirty water: Clean the product thoroughly, and fill it with fresh water.
White dust is forming on nearby
furniture.
• Hard water may deposit a certain of dust. Dust in the air also settles because of added
humidity in the room. Use distilled water if this becomes a nuisance.
Unit has stopped working. • No or low water. Unplug unit and refill tank.
Water is accumulating outside of unit or
area surrounding unit.
• Saturation of humidity. Lower mist control setting.
• Unit not level and water is accumulating. Unplug and place on level surface. Point spray
away from objects. Raise unit on a water-resistant level surface at least 60 cm from the
floor.
Water dripping when refilling. • Water remaining on bottom of tank. Wipe tank or tilt to drain before transporting.
Increased noise level. • Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed on a soft or
absorbent surface.
Flashing light symbols. • Indicates low water. Unplug and refill tank.
6- TROUBLESHOOTING GUIDE
If calcium becomes difficult to remove with a paintbrush:
1
. Fill the bowl with mixture of 1 tea spoon of white vinegar and 1 tea spoon of water.
2
. Let solution stand for 5 minutes.
3
. With the vinegar in the bowl, clean all interior surfaces with a soft cloth or brush to help remove scale.
4
. Also check mist nozzle and mist tube in water tank. Clean as needed.
5
. Rinse the Base thoroughly with water to remove scale and vinegar solution.
5d- END OF SEASON STORAGE
• Follow the Cleaning and Descaling instructions when the humidifier will be stored at the end of the season.
• Dry the humidifier completely before storing.
DO NOT store with water inside the bowl or Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR HOUS-
ING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE HUMIDIFIER OR PERSONAL INJURY.