3.
Confirm network and enter network password then “
Next
”. (Fig. 6)
4. Confirm that Wifi indicator (S10) on the Fresco touch panel is
on and blinking rapidly.
5.
Click on “
Confirm indicator rapidly blink
”, then click “
Next
”. (Fig. 7)
6. OS Home connects & configures Fresco Wifi air conditioner. (Fig. 8)
Figure 6
Figure 7
Figure 8
Connecting FRESCO to your network using OS Home App
4
S10
If resetting is necessary, refer to step
on previous page to
perform a reset for the FRESCO.
3
Connecting FRESCO using OS Home App
–
Alternate Method
4A
If unable to add FRESCO to OS Home App, follow directions
below to connect using
“
AP Mode
” option.
Do not
cycle power by unplugging power cord from outlet.
1. Reset Wifi indicator (S10) to
blink slowly
by pressing & holding
Fan/Wifi Mode (SW6) button for approximately 5 seconds.
2. Switch to “
AP Mode
” by tapping upper right corner. (Fig. 9)
3. Click
on “
Confirm indicator slowly blink
”, then click “
Next
” (Fig. 10)
Figure 9 Figure 10
SW6
S10
When the FRESCO is connected to the WiFi network, the Wifi indicator
(S10) stops blinking and remains switched ON steadily on the display.
Fresco will be
listed in OS Home app under “All Devices”
