Olimpia splendid AQUARIA 14P, Instructions For Installation, Use And Maintenance Manual

Page: 48 / 142

ENGLISH
EN - 18
3.2.b - ON/OFF key
Press the ON/OFF key (D6) and the appliance switches on, the display shows the percentage of humidity
detected.
To switch off the appliance, press the key ON/OFF (D6) again.
3.2.c - Fan speed
Press the “ Speed ” key (D1) to be able to select the fan speed:
High . --> Med . --> Min . --> High . --> ...
Once fan speed is selected, the respective Led (L1) remains on.
If “LAUNDRY” mode is active, fan speed cannot be changed.
3.2.d - Timer function
Press the “ Timer ” (D2) key to set the delay time for “ ON ” (start) or “ OFF ” (switch off) modes.
In “ ON ” mode, press the “ Timer ” (D2); key once or more; the display shows the delay time for the appli-
ance switch off in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance switches off (OFF); the (L2) led switches on in green.
In “ OFF ” mode, press the “ Timer ” (D2); key once or more; the display shows the delay time for the ap-
pliance start in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance starts (ON); the (L2) led switches on in green.
To cancel the Timer function programming, press the “ Timer ” (D2)key once or more until selecting “0”
or press the “ ON/OFF ” (D6) key.
3.2.e - Activation of the display
Press the “ Setting level of humidity ” (D4) and “ Led ” (D3) keys simultaneously, the detected room
temperature appears on the display.
Press the “ Led ” key (D3), the display and the active Led switch off, the machine continues to work.
3.2.f - Humidity level setting
Press the “ Setting level of humidity ” key (D4) to select the desired level of humidity in the room:
“CO” (Continuous cycle) ---> 30% ---> 35% ---> ... ---> 85% ---> 90% ---> “CO” (Continuous cycle) ---> ..
The settable value must be included between 30% and 90 % with 5% intervals.
After a certain period of operation, when the percentage of humidity in the room is lower than the set
value, the compressor stops temporarily.