Page 2 from 3
ATTENTION
!!
To disconnect the panel
’
s cables, you have to power off the mains power supply and
disconnect the battery
.
Back Up Operation
AC
Charge
The autonomous duration of battery during
On:
Good charge current.
emergency mode is at least the one that is
Οff:
No battery
(
No charging current or
stated in the list of the first page. During
disconnected battery
).
emergency mode, a LED strip test is also
performed.
Lamp fault
Οn:
faulty LED strip.
Resetting Errors
Off:
Good LED strip.
Push the Test button for 5 seconds, to
Fault
extinguish all the indicated LED errors.
Ο
ff
:
Battery OK.
Then the luminaire enters regular
operation
Blink
(
With
AC Charge LED
ON): Autonomy or
mode.
low battery problem
(the battery must be
replaced).
Indication LED status (with connected mains
Blink
(
With
AC Charge LED
Off):
power supply).
No charging current or disconnected battery
.
3
1
4
Installation instructions
Remove the front plastic cover by unscrewing the two
retaining screws
.
Pass the mains cables thru the hole of the plastic base.
Connect the live and the neutral wires to the terminal block
as shown in picture.
Mount the device by installing the included mounting
accessories in the holes or use the
Α-3018
mounting
springs for suspended seiling mounting
.
Install LED strip and batery connectors to the appropriate
PCB connectors.
Refit the front plastic cover by srewing the two
removed screws in step 1, and power on the device
.
1
2
3
4
5
6
5
2
L
N
General
:
1. Operations for installation, maintainance or testing must be done by authorized personel only
.
2.
The device must be connected to the mains power supply thru a fuse dependent by the total
amount of the line’s power load
.
In case of battery or light source replacement, these must be replaced by parts of the same
type, by the manufacturer or by a competent person.
4
t i
in battery recycling points. Do not incinerate.
3.
.
In case of inactive use for a period greater than 2 months, disconnect the battery by pulling
out the battery’s connector.
5.
I s not allowed to discard batteries in to common trash bins, they must be discarded
only
922044006_09_0
20
NOTE!!
After finishing the installation you must power the device
at least for 24 hours for battery charging to perform the
named autonomy.