functions combined with periodic manual testing ensure maximum security level. It is
suggested to carry out a test every 6 months or after a change in the position of the sensor. A
key element of its proper function is the air to be able to freely circulate inside it. So be careful
not to block the openings of the outer cover. Before the manual testing procedure it is
suggested to enable the special “walk in test” mode from the panel.
CAUTION !!
After installation the device must not be covered with dust or be painted or anything else
happen that will block the air to get to the sensor. Special attention must be given during the
installation and the use of the device, since the user assumes full responsibility for proper
operation afterwards.
Also, during site works place the plastic cover to the detector as shown in the picture below to
protect the device from dust.
Additional features of the device
:
o
optically visible LED.
- Integration of dynamic algorithms for noise and false alarm rejection.
-
Automatic fault diagnosis.
-
360
UID:
In every device there is a double sticker with the UID (Unique Identifier) number. This
921
660004
_0
9
_00
2
Page 2 from 4
