OLIMEX© 2012
MSP430-P2618 user's manual
CHAPTER 6 | HARDWARE
6.1 Introduction to the chapter
In this chapter are presented the connectors that can be found on the board all together with their
pinout. Proto area is shown. Jumpers functions are described. Notes and info on specific peripherals
are presented. Notes regarding the interfaces are given.
6.2 JTAG connector
The 14 pin JTAG connector provides the interface for JTAG programming/debugging. The plastic
connector is situated at the bottom of the board. The pinout can be found in the table below.
JTAG Connector
Pin #
Signal Name
Pin #
Signal Name
1
TDO
8
Not connected
2
P_IN/NC*
9
GND
3
TDI
10
Not connected
4
NC/P_OUT*
11
#RST
5
TMS
12
Not connected
6
Not connected
13
Not connected
7
TCK
14
Not connected
*Depending on the jumper
P_OUT/P_IN
position
Page 13 of 23