Olicom CrossFire 8730, Installation Manual

Page: 12 / 84

2
CrossFire 8730 Switch Installation Guide, DOC-7046 v. 1.2 Introduction
Front Panel Details
The connectors and LEDs (light emitting diodes) on the front panel of the
CrossFire 8730 Switch are displayed in Figure 2. For detailed explanations,
please see the tables and sections below.
Figure 2. Front Panel LEDs, Switches, and Connectors
Connectors and Push-Buttons
The table below gives an overview of the connectors and push-buttons on the front
panel. For detailed descriptions see the following pages in this chapter.
Name Description
Ports 1 to 20 UTP/STP Token-Ring RJ-45 ports.
Ports 19 and 20 can attach to a MAU/CAU RI/RO port.
(MAU=Media Access Unit/CAU=Controlled Access Unit)
Ports 21, 22, 25, and 26 UTP5 10/100 Mpbs Fast Ethernet RJ-45 ports.
MANAGEMENT Console connection with DB-9 connector.
RST Reset—full system reset of software and hardware.
SYS REQ (unlabeled) System Request—initiates a set of system request menus
on the attached console. If depressed for more than 5
seconds, the switch will accept download of the main
image from the serial port via the X-modem protocol.
Table 1. Front Panel Connectors and Push-Buttons
3 2 5 4 8 7 6 10 9 15 12 11 14 13 17 16 19 18 20
STACK-LINK
ATTACH RX TX
DIAG PWR RST ERR MANAGEMENT
21
FAST ETHERNET
21-22 25-26 22 26 25
1
Fast Ethernet Translation Switch
CrossFire 8730
FAULT
STATUS
FAULT
STATUS
LINK
100
ACT
LINK
100
ACT
LINK
100
ACT
LINK
100
ACT
RST button (reset)
ERR LED
DIAG LED
PWR LED
port
(Out-of-Band
Management)
MANAGEMENT
SysReq button
FAULT LED for
Fast Ethernet port
STATUS LED for
Fast Ethernet port
STACK-LINK ATTACH LED
LINK LED for Fast Ethernet port
100 LED for Fast Ethernet port
ACT LED for Fast Ethernet port
STACK-LINK RX LED
STACK-LINK TX LED
Port ACT LED
Port INS LED
20 Token-Ring UTP/STP ports 1 - 20
4 Fast Ethernet ports (21, 22, 25, 26)