Oldham iTrans 2, Installation And Operation Manual

Page: 85 / 106

85
13 Unsigned-8 RTC Year Channel 2
14-17 Unsigned-32 Total Operation Time (In Minutes) Channel 2
Command 141 – Write User Configuration – Response/Request Length: 36 Bytes
Byte Number Parsing Parameter
0-3 Float IEEE 754 Low Alarm Threshold Channel 1
4-7 Float IEEE 754 High Alarm Threshold Channel 1
8-11 Float IEEE 754 Analog Output Range Channel 1
12-15 Float IEEE 754 Cal Gas Value Channel 1
16-17 Unsigned-16 Calibration Interval In Days Channel 1
18-21 Float IEEE 754 Low Alarm Threshold Channel 2
22-25 Float IEEE 754 High Alarm Threshold Channel 2
26-29 Float IEEE 754 Analog Output Range Channel 2
30-33 Float IEEE 754 Cal Gas Value Channel 2
34-35 Unsigned-16 Calibration Interval In Days Channel 2
Table A - 4 Write Commands
Operation Commands
Operation commands are similar to write commands where specific values
are written on specific sensor to get the desired operation done. The details
are enlisted in the Table A - 5.
Command 150 – Start/Abort Selected Live Channel Calibration – Response/Request
Length: 2
Byte Number
Parsing Parameter
0 Unsigned-8
Selected Sensor (“1 = Sensor 1” and “2 = Sensor
2”)
1 Unsigned-8 Calibration Condition (“1 = Abort” and “2 = Start”)
Command 151 – Start/Abort Selected Live Channel Zeroing – Response/Request
Length: 2
Byte Number
Parsing Parameter
0 Unsigned-8
Selected Sensor (“1 = Sensor 1” and “2 = Sensor
2”)
1 Unsigned-8 Zeroing Condition (“1 = Abort” and “6 = Start”)
Table A - 5 Operation Commands
# # #