4
INSPECT ALL COMPONENTS BEFORE USE
.
DO
NOT
ATTEMPT
TO
USE
THE
HOTDOG
ROLLER
MACHINE
IF
ANY
PARTS
ARE
DAMAGED
OR
MISSING.
1.
Locate and remove the pair of screws on the inner left and right sides of
the roller base and set aside.
2.
Position the back glass mount onto the roller base. Reinsert the screws
removed in step 1 and hand-tighten as it may need to be adjusted. Repeat
for the remaining 3 mounts.
3.
Insert one of the small side glass panels into both the front and back
mounts on one side of the machine with the curved side of the glass facing
the back (away from the controls). If needed, adjust mounts by sliding
forward or backward until the glass is snug; tighten screws to secure.
Repeat for the other side.
4.
Place the large curved glass shield into the back mounts pushing gently
all the way down into the channel. Check to make sure the edges of the top
and side glass pieces are flush.
5.
Place the stainless steel trim plate over the edge of the top class,
aligning the holes with the glass.
6.
Insert a bolt through the trim plate and glass, then secure with nut. DO
NOT OVERTIGHTEN as this may crack the glass.
ASSEMBLY INSTRUCTIONS
