English
MANUAL PROPORTIONAL THERMOSTAT
“Thermotronic”
(
model
TS
-
TT
)
This very exact “Thermotronic” thermostat is a proportional controller. This means when you switch on the
thermostat the heating will work 100% till
just before
the temperature has reached the setting point. On that
moment the thermostat will give power pulses to the heater to keep the temperature at the same level. This pulsing
you can see by the red LED-lamp.
The accuracy of this thermostat is between 0.05 and 0.08 degree Celsius!
In case you don’t reach this accuracy this can have the following courses:
thermometer not at same place as the sensor
big difference between the heater and the sensor
heater with too much power!
cabinet with bad isolation
THE THERMOSTAT:
The “Thermotronic” has 2 setting knobs, control 1 and control 2.
control 1: for setting temperature between 28 and 42 degrees Celsius
control 2: fine regulation for adjustment less than 1 degrees Celsius
1.
The 2 meter power cord with plug is to connect to your power supply (220 Volt).
2.
The thin round cable with at the end the small NTC sensor is to register the temperature.
3.
The third cable of about 1 meter with the 2 connection ends is to connect to the heater.
CONNECTION:
1.
Connect the cable as described at point 3 to the heater.
2.
Make sure to put the sensor at the right place in the incubator (near the eggs). In case of a still air incubator it is
very important to put the sensor at egg level. Also with a forced air incubator it’s better to have the sensor near
the eggs.
3.
Put the plug into the power supply (220-240 Volt).
4.
Set the fine regulation at 50% and use the other (left) knob to set the good temperature.
5.
Use the fine regulation for fine adjustment.
Attention
:
This thermostat is only working with a connected heater or bulbs. Without you won’t see the LED-
lamp working.
Technical details
:
220/240 Volt (AC)
maximum 400 Watt
safe sensor Voltage
GUARANTEE: 12 MONTHS (NOT VALUED IF WRONG CONNECTED)
THE INSTALLATION OF THIS PRODUCT MUST BE CARRIED OUT BY A QUALIFIED EXPERT.
OLBA B.V.
Pasteurweg 3
7741 LB COEVORDEN
THE NETHERLANDS