5
1. Rotate the Seaming Lever to position 0 as shown. The black
knob should be somewhere near centerline of the seamer.
2. Place an end (can top) onto the can to be seamed.
3. Set the can onto the lower adapter, and lean the can back
against the Can Guide.
4. Raise the Base Lever until it is locked into place. Note:
the lever will not lock in-place without a can placed on the
lower adapter.
5. Turn the Power Switch to “on”
6. Rotate the Seaming Lever to the right until the first
operation Seaming Roller contacts the rim of the can end, then
continue rotating the lever until it contacts the hard-stop.
It should take about 2sec to rotate from first contact to the
stop. Hold the lever against the stop for a second or two,
then rotate the lever back to position 0. Note: it doesn’t
take much force to seam the can; as soon as the lever stops,
it has gone far enough.
7. Rotate the Seaming Lever toward position 2 until the second
operation Seaming Roller contacts the rim of the can end.
Continue rotating the lever to until it contacts the hard-stop.
It should take about 2sec to rotate from first contact to the
stop. Hold the lever against the stop for a second or two,
then immediately rotate the lever back to position 0.
8. Turn the Power Switch to “off”
9. Rotate the Base Lever down to release the sealed can.
If the can stops spinning during the seaming cycle, its likely
that the lever is being rotated too quickly.
Make sure to not hold the lever against the stops at position 1
and 2 for too long; eventually the seaming rollers will create
a rough surface on the edges of the can.
