20
Connection of T Sensor
Plug the T Sensor to the green port placed on the rear panel of UNO-CONTROLLER (see Figure 20).
UNO-CONTROLLER
T Sensor
Figure 20. T Sensor - Connection.
Tip
►
T Sensor has two connector pins of different dimensions. Make sure to follow the right direction of
entry into the openings UNO-
CONTROLLER’s green connector. Insert the widest connector
pin of T Sensor
into the bottom opening of UNO-
CONTROLLER’s green connector.
Connection of the OBJ-COLLAR (optional)
To connect the OBJ-COLLAR to UNO-CONTROLL, follow the instructions below:
1.
Assembly the OBJ-COLLAR around the objective heater (see Figure 21).
Objective Band Heater
1
2
Objective Band Heater
Velcro Tape
Figure 21. OBJ-COLLAR - Assembly.
2.
Connect the OBJ-COLLAR cable to its corresponding connector of the WP-CABLE (see Figure 22).
