H301-MIZAR-TILT
User Manual
REV 02
www.oko-lab.com
Pa
ge
7
6.
Working with MIZAR-1x22by40 Sample Holder
The OKO-MH fits into the Chamber Base and it is held in place by the magnetic clamps in order to prevent movement
inside the opening on the base. To insert the MIZAR-1x22by40, follow the steps shown in Figure 8 and listed below:
1.
Insert the MIZAR-1x22by40 into the Chamber Base (see image 1 in Figure 8).
2.
Place the magnetic clamps over the insert (see image 2 in Figure 8), then push down the head of the clamps sim-
ultaneously and move it in the direction shown in the image 3 of Figure 8.
3.
Insert the Light Trap into the Chamber Base as shown in image 4 in Figure 8.
4.
Close the Chamber Base with the Lid (see image 5 and 6 in Figure 8).
NOTE:
Please follow the same steps also to insert the Mizar Cube Holder.
Figure 7. Base Top view.
