Okofen PELLEMATIC SmartXS, Installation Manual

Page: 31 / 100

Disconnection of the cable routing
31
10.2 Disconnection of the cable routing
The cable routing is divided into three main groups:
Cable connection Disconnection Time of disconnection
1 Cables to operating
device The operating device and boiler controller form
part of the accumulator front panel. They are
removed together. No dismantling
necessary!
2 Cables to boiler
controller Disconnect the cable harness below the hop-
per. Loosen all pluggable connections at the
components and lay the cables in an orderly
manner by groups back to the boiler controller.
If the components have non-pluggable connec-
tions, loosen the pluggable connections at the
boiler controller and lay the cables back to the
components. After dismantling ca-
sing parts 1–5 and befo-
re dismantling the
remaining casing parts
A detailed description of the individual cable connections and the cable routing can be found in chapter Cab-
le routing
Make sure that all plug connectors are unpluged before removing the assembly group
10.3 Dismantling of hopper with vacuum turbine and burner
Note:
Check that all cables have been disconnected and pulled back.
Installation Manual PELLEMATIC® SmartXS